Q&A: How to remove the two remaining ujoint bearings from the driveshaft on a 1992 dodge ram b250 ram van? | SKF Bearing Online

Q&A: How to remove the two remaining ujoint bearings from the driveshaft on a 1992 dodge ram b250 ram van?

Question by bill e: How to remove the two remaining ujoint bearings from the driveshaft on a 1992 dodge ram b250 ram van?
how to get the two remaining ujoint bearing( rear ujoint) out of the drive shaft of a 1992 dodge ram250 van, automatic trans, 318cu engine, 2 wheel drive. I removed the drive shaft from the van. There are two remaining bearings that need to be removed. This ujoint does have a zirk fitting it that matters.

Best answer:

Answer by Dave
It needs to be pressed out. Take it to a shop with a press.

Know better? Leave your own answer in the comments!

Tags: 1992,92 dodge ram 250 drive shaft,b250,bearings,cross reference dodge bearings,Dodge,dodge bearing cross,dodge bearing cross referance,dodge bearing cross reference,dodge bearing cross reference chart,dodge bearing cross reference to timken,dodge bearing to linkbelt bearing cross reference,dodge bearings,dodge bearings cross reference,dodge bearings online,dodge ram 250 drive shaft removal,dodge ram drveshaft how to,dodge ram u joint failure,dodge skf cross reference,drive shaft u joint removal dodge ram,driveshaft,from,how to remove stock u joint,how to remove u joint,how to remove u joints bearings out if drive shaft on dodge van,joint bearing,remaining,remove,remove rear u-joint in dodge 2500,removing stock u joint from dodge ram,removing u joint from dodge,shaftu 3 online,skf crosreference,skf driveline bearing installation,skf to dodge cross reference bearings,skf u joints,skf ujoints,stock u joint removal,u joint bearing press,ujoint,ujoint bearings

Related Products